The following procedure explains the recommended method of removing and replacing a front wheel on your Gaucho Grande electronic toy.

WARNING: Disconnect the battery prior to beginning this procedure.

1. At the wheel being replaced, remove the red center cap.
2. Remove the loc k nut and washer from the spindle end.
3. Pull the old wheel off the spindle. Do not remove the flat washer that lays against the spindle flange. Remove the chrome trim ring from the outer face of the old wheel.
4. On the reverse side of the new wheel be sure the center bushing is in place. Install the chrome trim ring into the front face of the new wheel.
5. Slide the new wheel into the spindle. Be sure the wheel is fully seated against the flat washer and spindle flange.
6. Secure the wheel to the toy using the lock nut and washer.
7. Install to center cap.
8. Test the toy by spinning the wheel.