- Remove the single screw on the back of the driver’s seat base. Pull the seat belt out of your way.
- Lift the seat base up. Remove the two screws. Lift the seat up and pull forward the dislodge the back tabs of the seat.
- Gently pull the accelerator switch off the circuit board connector.
- Turn unit on its side. Pry the wire cover off.
- Pull the single sheath accelerator wire out. This is the wire you already disconnected from under the seat.
- Gently pry the retainer off to release the wire grouping.
- Pry up the accelerator pedal from the floor board.
- Remove the wires and pull the accelerator switch and attached sheathed wire out of toy.
- Pry up the bottom of the pedal to remove from the pedal base. Pull end up to remove the front tab. Remove.
- Thread the new accelerator wire through the pedal base and snap in the pedal by inserting the tab in the front first then snapping to the base.
- Thread the accelerator wire through the hole. Snap in the pedal base into the floor board by inserting the top tabs in first.
- Turn the toy on its side. Take the accelerator wire and follow the main wire harness passed the gear shift and thread through the hole.
- Attach wire harness cover. Gather the wires together and place between the two tabs on the cover. Insert the 2 rear tabs into the toy. Bring the cover toward the front making sure the wires are inside the compartment and snap cover onto toy.
- Place the wires within the plastic C clamp and insert the plastic peg. Push the retainer onto the peg with the provided push tool.
- Set the unit on its wheels. Look under the seat compartment for the loose accelerator wire that you pushed through the hole. Attach the accelerator connector to the circuit board.
- Place your seat assembly onto the unit by inserting the rear tabs in the slits and push towards the back of the unit. Insert the 2 screws.
- Lower the seat and insert screw.