- Insert the plugs in the handle bar.
- Insert and fit the handlebar with the screws provided.
- Place the bucket block on the shovel, arranging the pieces. Fasten the pieces together with screws and nuts, working with a wrench and a screw-driver from the side shown in the figure.
- Partially insert the second screw on the opposite side, to make it easier to carry out the next operation.
- Insert the spring into the hole in the bucket block. Turn the spring while pressing downward.
- Push the screw into the spring; place a washer and a nut on the screw.
- Tighten the screw, using a wrench and a screwdriver.
- Slip the bucket drawstring through the special hole on the shovel.
- Place a cap in the special tool.
- Fasten the bucket drawstring by pressing the cap all the way in.
- Using two wrenches fasten one of the two lock nuts on the bucket drawstring.
- Slip out the bucket drawstring with a washer taking care not to lose it.